Fostex VF08 Manuel d'utilisateur télécharger pdf (Page 93)

Save/Load of Song data

Blinking

Saving a WAV file

You can save a WAV file.

Make sure that the DOS-formatted disk with FAT16

is set. The following procedure assumes that the

newly formatted "clean" disk is used for backup.

Press the [SETUP] key to enter the setup mode.

The display shows the screen for selecting the Setup

menu.

Use the [JOG] dial to select "Save PGM" and press

the [ENTER/YES] key.

The display shows the screen for selecting the device

to which the data is saved. "SCSI" blinks.

While "SCSI" is blinking, press the [ENTER/YES] key.

The display shows the screen for selecting the backup

mode (FDMS 3 or WAV), where "WAV" blinks. (When

a DOS-formatted disk is set, "WAV" initially blinks.)

While "WAV" is blinking, press the [ENTER/YES] key.

The display shows the screen for selecting On or Off

of the Edit Source Export function, where "Off" blinks.

You can switches between On and Off by using the

[CURSOR] keys .

If you save all data from "ABS 0" to "REC END" (in

most cases), you do not have to change the setting

here.

The Edit Source Export function allows you to save

the desired range of data between the Start and

End points which are set when executing the Copy-

paste or Move-paste function.

Therefore, if you want to save only the specific range

of data, you have to register the Start and End points

before the save operation.

See "Track Editing" in "Recorder Function" for

details about how to set the Start and End points.

<Note>

If you save all data from "ABS 0" to "REC END", make

sure to set the Edit Source Export function to Off.

While "Off" is blinking, press the [ENTER/YES] key.

The display shows the screen for selecting a program

to be saved. The program number currently selected

blinks, while the data size of the program is shown.

Use the [JOG] dial to select a program to be saved

and press the [ENTER/YES] key.

The display shows the screen for selecting a track to

be saved. Initially, "All Track" blinks.

By rotating the [JOG] dial, you can select "From ** To

**" (where the left field blinks initially) instead of "All

Track".

If you save data for all tracks (1 through 24), select

"All Track". If you save data for any specific track(s),

select "From ** To **" and specify the desired track

numbers.

By rotating the [JOG] dial while the left ("From") field

is blinking, you can select the track number from 01

through 24. The number in the right ("To") field

automatically follows the number in the left field (i.e.

numbers in the left and right fields are always the same).

Therefore, if you want to save a single track, you just

have to set the right ("From") field and do not have to

set the right ("To") field. For example, "From 02 To 02"

will save only track 2.

To specify tracks 5 through 12:

•Enter "05" to the left field while the left field is

blinking.

•Press the [CURSOR </>] key to make the right field

blinking.

•Enter "12". (Note that the number for the right field

must be equal to or larger than the left field.)

Finally the screen shows "From 05 to 12" to save tracks

5 through 12.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 117 118

Commentaires sur ces manuels

Pas de commentaire

Fostex VF08 Manuel d'utilisateur Page 93

Commentaires sur ces manuels

Produits connexes et manuels pour Pianos numériques Fostex VF08