Fostex MR-8MKII Manuel d'utilisateur Page 22
- Page / 154
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
22
MR-8mkII Owner’s Manual (Preparation)
When turning off the power, make sure that the
MR-8mkII is stopped.
If any peripherals are connected, turn off the power
of each unit in the reverse order of the order for
turning on the power.
<Note>:
If you turn off the power while the MR-
8mkII is accessing the card, there is a risk for de-
stroying the recorded song or the whole card.
You do not need any shutdown operation before
turning off the MR-8mkII. The MR-8mkII keeps
data recorded just before turning off the power.
So you can concentrate on the recording opera-
tion.
Turn off the power
<Notes when peripheral devices are connected>
When peripheral devices are connected to the
MR-8mkII, turn off the power of each device in
the following order.
• Turn off the external monitor device (amplifier,
powered speaker, etc.).
• Turn off the MR-8mkII.
• Turn off the external device which send
signals to the MR-8mkII input(s).
While running the MR-8mkII on batteries, if the
battery voltage is getting low, "Low Battery!" starts
flashing in the song name field. In this case, inter-
rupt the operation and replace batteries with new
ones.
<Note>:
If you continue operation after "Low Bat-
tery!" starts flashing, batteries are completely ex-
hausted finally and the display shows the screen
below, while the MR-8mkII accepts no operation.
We recommend replacing batteries before they are
completely exhausted.
Flashing
Low battery indication
The MR-8mkII provides a backlight facility, which
allows improving observation in poor lighting con-
ditions. To turn on the backlight, set the [POWER]
switch to the "LIGHT" position.
<Note>:
Unless really needed, we recommend not
turning on the backlight when running the MR-
8mkII on batteries. Turning on the backlight con-
sumes batteries, making the battery life shorter.
Backlight facility
POWER USB FOOT SW
ON
DC IN
LIGHT
OFF
12V
INPUT A SELECT
INT MIC
GUITAR
MIC/LINE
ON
LIGHT
OFF
"LIGHT" position
The MR-8mkII also has a facility for adjusting the
display contrast. See page 32 for details.
"OFF" position
POWER USB FOOT SW
ON
DC IN
LIGHT
OFF
12V
INPUT A SELECT
INT MIC
GUITAR
MIC/LINE
ON
LIGHT
OFF
- Owner’s Manual 1
- SAFETY INSTRUCTIONS 2
- Important Safety Instructions 3
- Table of contents 4
- Read this chapter first! 9
- Introduction 10
- MR-8mkII main features 10
- Precautions before using 11
- The basics of the MR-8mkII 12
- About song 13
- Time base 14
- [TRIM] control 15
- Preparation 17
- Preparation of power supply 18
- About song modes 19
- Fostex website: 19
- <Important!>: 20
- Turning on the power 21
- Turn off the power 22
- Low battery indication 22
- Backlight facility 22
- Creating a new song 23
- How to enter a name 24
- Names and functions 25
- Top panel 1 26
- Top panel 2 27
- Rear panel 29
- Side panel 30
- Bottom panel 30
- LCD display 31
- Selecting a time base mode 32
- MENU mode screen 33
- Warning message 33
- Basic recording operations 35
- Input connection 36
- Selectable recording tracks 37
- Recording onto a single track 38
- <Notes>: 39
- Overdubbing basics 42
- Basic mixdown 44
- 3 x cueing 46
- Play mode 47
- Auto play mode 48
- Auto return mode 48
- Loop mode 48
- Locate function 50
- • To set the LOCATE B point: 51
- • To set the LOCATE A point: 51
- Locating 52
- Punch in/out 53
- Auto punch in/out 56
- [UNDO/REDO] key 58
- Using effects 59
- Mic simulation effects 60
- Amp simulation effects 60
- Selecting an effect type 61
- Selecting a delay type 61
- [REVERB / DELAY TIME] control 62
- Track bouncing 65
- Preliminary knowledge 66
- Signal flow of track bouncing 67
- Rehearsal of track bouncing 68
- Actual track bouncing 69
- Typical bouncing (Fig. 1) 74
- Rhythm guide function 75
- Creating the conductor map 78
- Editing the bar offset 81
- Setting the tempo map 82
- • Editing a tempo event 84
- MIDI synchronization 85
- Synchronization using MTC 86
- Connection 87
- Song management 89
- Selecting the desired song 90
- Editing a song name 91
- Deleting an unnecessary song 92
- Protecting a song 93
- <Note> 94
- Track data editing 95
- Erasing track data 96
- Copying/pasting track data 97
- Moving track data 99
- <Note>: 100
- Exchanging whole track data 101
- Part data editing 103
- Erasing the part(s) 105
- Copying/pasting the part(s)-1 106
- Copying/pasting the part(s)-2 108
- Pasting clipboard data 110
- Moving the part(s) 111
- Exchange the part(s) 113
- WAV file conversion 116
- <Editing a file name> 117
- Notes on exporting a file 118
- <Important note> 119
- Protecting the card 120
- Archiving a song 121
- Burning an audio CD 123
- Read this page before using! 124
- #####001.wav 125
- #####002.wav 125
- #####003.wav 125
- #####008.wav 125
- *********.wav 125
- Viewing TOC 129
- Other functions 131
- CompactFlash 132
- Card formatting 132
- Peak hold time setting 133
- Auto Delete function on/off 135
- Beat resolution mode on/off 136
- Phantom power on/off 137
- Initializing the MR-8mkII 138
- Troubleshooting 139
- Troubles for recording 140
- Troubles for playback 141
- Troubles for effect 141
- Other troubles 142
- Troubles for USB connection 142
- Troubles for power supply 142
- MR-8mkII Specifications 143
- Specifications 144
- Physical dimensions 145
- Block diagram 146
- NEW SONG 147
- MIDI Implementation Chart 148
- Declaration of EC Directive 150
- FOR THE US CUSTOMERS ONLY 151
- SHIPPING 152
- FOSTEX CO 154
- FOSTEX AMERICA 154
Produits connexes et manuels pour Audio Fostex MR-8MKII
(122 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.083 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels