Fostex VF160EX Manuel d'utilisateur Page 37
- Page / 158
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
37
flashing
Punch IN/OUT recording enables you to record over previously recorded parts. This function comes in handy in
the following cases.
* If a recording is unsatisfactory in either recording or performance and you want to redo it.
* If you want to record a solo part to another track while listening to the backup tracks.
PUNCH IN refers to the process to switching from PLAY to REC. On the other hand, PUNCH OUT refers to the reverse
process, to switch from REC to PLAY. The time to punch in is called the PUNCH IN point, and the time to punch out
is called the PUNCH OUT point. The VF160EX features the following 3 types of PUNCH IN/OUT modes.
* MANUAL PUNCH IN/OUT using the key on the main unit
This feature is used for rough recordings. Manual punch in/out is not recommended during a performance since the process
requires using your hands.
* PUNCH IN/OUT using the foot switch
Recording is possible even during a performance since all punch in/out processes are controlled from the foot switch.
* AUTO PUNCH IN/OUT
Detailed recording is possible since recording takes place with the punch in/out time preset (programmed) prior to the
recording.
Use the [DIRECT-REC TRK] key to put the track to record in the READY mode. The [TRIM] must be adjusted to an optimal
gain according to the input monitor. When this is set, do the following:
Manual Punch IN/OUT
Punch IN/OUT with Foot switch
Tips: Rehearsal
Step on the foot switch while the [STOP] key is depressed
to start rehearsing the recording (“Rhrsl On” will appear
on the LCD then “RHSL” will light ON).
Rehearsal instructions are the same as recording with
the foot switch.
However, stepping on the foot switch will go to input
monitor, and stepping on it again will cancel it. To cancel
the rehearsal mode, step on the foot switch again while
the [STOP] key is depressed (“Rhrsl Off” will appear on
the LCD then “RHSL” will light OFF).
1. Press the [PLAY] key from the point immediately before
starting the recording and then playback.
2. Press the [RECORD] key while the [PLAY] key is
depressed to start recording (punch in).
3. Recording is canceled and playback takes place if only
the [PLAY] key is pressed (punch out).
1. Connect a “Fostex Model 8051” foot switch to the [FOOT
SW] jack on the rear panel of the VF160EX.
2. Press the [PLAY] key from the point immediately before
starting the recording, then playback.
3. Recording starts by stepping on the foot switch (punch
in).
4. Recording is canceled and playback takes place when the
foot switch is stepped on again (punch out).
2
1
RL
IN OUT
IN OUT
AVIS:
OPTICAL
AC-IN
POWER
FOOT SW
DIGITAL/DATA
MIDI
ST OUT
AUX SEND
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
Foot Switch
Tips: Foot Switch
Use the optional Fostex Model 8051 or a universal
foot switch of the unlatched type.
Punch In/Out
Step on the foot switch.
(Punch In)
Recording Track
Playback Record
Playback
Step on the foot switch again.
(Punch Out)
Press [RECORD] key while holding the [PLAY] key.
(Punch In)
Recording Track
Playback Record
Playback
Press the [PLAY] key only.
(Punch Out)
- Operation Manual 1
- SAFETY INSTRUCTIONS 2
- Precautions 3
- Index for Applications 4
- Please read page 138 5
- Table of Contents 6
- Introduction 8
- Product Features 8
- Before Operating 9
- For DIRECT recording: 10
- For BUSS recording: 10
- RECORDING System 11
- REMAIN Indicator 11
- CHANNEL and TRACK 12
- ADDITIONAL TRACK 12
- [CH STATUS/CH SEL] Key 13
- TIME BASE 14
- Names and Functions 15
- Top Panel 16
- 14. [SCENE-STORE/MAP] Key 17
- Rear Panel 22
- Front Panel 22
- Reformatting the hard disk 23
- Replacing a hard disk 24
- Formatting the new hard disk 26
- Sequencer 28
- PC w/sequence 28
- MIDI OUT 28
- Switching the Time Base 29
- Switching with [DISP SEL] Key 30
- Recording to One Track 31
- DIRECT Recording 31
- WARNING! 32
- RECORDING to 2 Tracks 33
- Locate Function 34
- Locating an event memory 36
- Punch In/Out 37
- • AUTO PUNCH IN/OUT rehearsal 38
- • AUTO PUNCH IN/OUT take 38
- Track Exchange 39
- Equalizer Adjustment 40
- Level Adjustment 40
- PAN Adjustment 40
- Effect Send Level Adjustment 41
- Modifying Effect Type 41
- Mix Down 42
- Description of BUSS RECORD 43
- SCENE SEQ 44
- Recording 46
- <Hints> 50
- Adjusting EQ 51
- Controlling Effect send level 52
- Controlling AUX SEND level 53
- Controlling fader levels 54
- Setting the compressor 54
- Channel view 55
- Effect Edit Mode 56
- Effect types preset for EFF 1 57
- Effect types preset for EFF 2 58
- • To mute the effect sound: 59
- • To cancel muting: 59
- Scene Memory 61
- Level adjust 62
- Fader adjust 62
- Recalling a scene memory 62
- Clearing a scene memory 63
- Scene Event Map 64
- Creating the scene event map 65
- Deleting an event memory 65
- Executing the scene sequence 66
- Chapter 4 Recorder Functions 67
- Variable Pitch Control 68
- Auto Function 69
- Creating a New Program 70
- Selecting a Program 71
- Erasing a Program 71
- Editing a Program Title 71
- Copy & Paste 72
- Move & Paste 72
- Pasting Data 73
- UNDO/REDO Paste 74
- Erasing Data 75
- • Exchange in 8-track units 77
- Applications of DIRECT RECORD 78
- Can’t New PGM! 79
- Over time! 79
- [HOLD/>] 83
- [REWIND] 83
- Connecting the sound source 85
- Preparations to record 85
- Ping-Pong RECORD 86
- Metronome Function 87
- Digital Recording 88
- Selecting a track to record 89
- Starting to record 89
- MIDI Clock Sync System 90
- Connecting external equipment 91
- Setup of the VF160EX 91
- Execution of recording 91
- Setup of external equipment 92
- Confirming MTC sync/MMC 92
- <One Point Advice> 94
- Chain play function 96
- Making the chain play list 97
- Setting the chain play mode 99
- Editing the chain play list 100
- <Note> 101
- Audio CD playback mode 103
- ******About song data****** 106
- •Memory data: 107
- •SETUP mode: 107
- Setting the external device 108
- Saving data 108
- Loading data 110
- Save/Load using CD-RW/CD-R 112
- <Notes on care of disc> 113
- • Creating an audio CD 114
- • Loading an audio CD data 114
- <Hint 1> 116
- <Hint 2> 116
- • To eject the disc 116
- <About load error> 119
- About file names of WAV file: 120
- Saving a WAV file 121
- CD-R/RW drive 123
- ###### 01. WAV 123
- ###### 02. WAV 123
- ###### 24. WAV 123
- Making an audio CD 125
- <Hint> 127
- • If you erase recorded data: 127
- • If you eject the disc: 127
- Program 1 128
- Program 2 128
- Loading from an audio CD 129
- Chapter 7 SETUP mode 132
- To enter the SETUP mode 133
- Deleting a Time Signature 134
- Setting a tempo [“Tempo Set”] 135
- <Notes> 139
- <Important> 142
- Flashing 143
- <Caution> 144
- <CAUTION!> 147
- <Important!> 148
- Trouble Shooting 149
- Having trouble Editing? 150
- Model VF160EX 151
- MIDI Implementation Chart 151
- (Digital Multitracker) 151
- MMC Command List 152
- Inquiry Message List 152
- Recording/Reproducing 153
- Input/Output 153
- Accessories 154
- Block Diagram 155
- Declaration of EC Directive 156
- FOSTEX CO 158
- FOSTEX AMERICA 158
© 2020, manymanuals.fr. Tous droits réservés | 3.547 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels